Descripción general:
2019 Vermeer D20x22 S3 Directional Drill:
-1738 hours.
Sistemas de localización:
-2018 DigiTrak Falcon F5 Locator.
-2023 DigiTrak F5 Transmitter (seller states: purchased 8/2023).
-2018 DigiTrak Aurora AF8 Display.
-2018 DigiTrak F5 Battery Charger.
-(2) Batteries.
LOCATING EQUIPMENT NOTES:
-LCD Graphic Display.
-Target Steering with Aurora touch Screen Display.
-Wideband Transmitter Supports Frequencies of 4.5 kHz to 45kHz.
-Transmitter Pairing Through Use of Infrared Ports.
-Transmitter Depth up to 100 Feet.
-24 Transmitter Roll Positions.
-0.1% Pitch Resolution.
-Supports Data Log and Log While Drilling Functions.
-Fluid Pressure Transmitter Capable.
Seller States: All items are in good working order. No Factory Hard Cases.
Sistemas de mezcla:
-2020 Vermeer MX300 Mud Mixing System (660 hours).
-(2) x 2020 Vermeer TK750 750 Gallon Narrow Tanks.
MIXING SYSTEM NOTES:
-Power Pack with two 750 Gallon Narrow TK750 Tanks.
-23 hp Kohler ECH 730 EFI Gas Engine with Electric Start.
Seller States:
-All items are in good working order.
-The mixing system and tanks were ordered brand new and not a demo system.
Tubo:
410 Feet of 2.06 Firestick Drill Rods.
Seller States:
-Rods on the machine are in decent/usable shape, but getting old.
-The overall condition of the rods are fair, getting thin at the joints, with maybe 20% of them having a bit of wobble (nothing too excessive).
Accesorios:
-Vermeer X3 System Direct-Connect Head with Back Teeth.
-Trident Rock Bit with Pullback Lug (seller states: Trident bit has been re-surfaced one time by Vermeer).
-Paddle Adapter with 4.5 inch Ace Extreme Bit (purchased 3/2023).
-Vermeer Quickfire Head.
-4.5 Inch Ace Extreme Bit.
-Cutter Collar.
-New Starter Rod.
-Spare 5.5 inch Ace Extreme Bit.
-6 Inch Fluted Reamer.
-12 Inch Fluted Reamer (seller states: 12 inch has never been used).
Trabajos/modificaciones recientes:
Seller States: Sub-saver recently replaced and in good shape with around 30 hours on it.
Maintenance: All regular maintenance and minor repairs have been performed in-house.
Recent Repairs / Modifications: Recently replaced slides on Kelly (upper outboard and lower inboard). Replaced hydraulic pump (4/2023) due to a cracked housing and leak at output fitting, not an internal/catastrophic failure but hydraulic fluid was drained and replaced at that time. Deutz replaced EGR valve and manifold and did a coolant flush (5/2023).
Known Issues: Rods are getting old. The rotation encoder not on unit (removed after damage). LED lights not functional. No pressure washer hose or wand. Auto-rod-greasing system is all present but hasn't been used for the last couple years. Small intermittent seepage on front rack lift cylinder.
Información adicional:
DRILL NOTES:
-Vermeer D20X22S3, Demo 2019
-74 HP Deutz Turbocharged Liquid Cooled TD2.9 Tier 4 Diesel Engine
-2,250 lbs of Rotational Torque
-19,550 Lbs of Thrust/Pullback
-R.A.T.T. System-Job Management Tool for Tough Ground Conditions
-Auto Pullback System
-Min Transport at 47" Wide
-Carriage Speed @ 167 Ft/Min High and 114 Ft/Min Low
-257 RPM Maximum Spindle Speed
-25 GPM Water Pump at 1,000 psi Max Pressure
-Rack N Pinion System (Bolted On Sections)
-Dual Joystick Common Platform Controls
-25 Gallon Fuel Capacity @ 4.5 GPH
-30 Gallon Hydraulic Fluid Capacity
SELLERS NOTES: 2019 Vermeer 20X22 S3 in good shape with 1783 hours. Working unit. Starts and runs fine. Hydraulics and water pump are strong, and have always used a Banjo pre-screen for water. Rubber tracks in good condition and machine drives straight. Auto-loader works as it should and all magnets are present. Have not had any issues with sensors or wiring harnesses.
This inspection report has been furnished solely for informational purposes and it is not to be construed in any way as a warranty or guarantee on the condition of the equipment. Buyers should confirm the accuracy of this report to their satisfaction prior to purchase. Buyer agrees to hold harmless HDD Broker, the seller, and the inspecting agent.
Price is FOR ALL.
-NO TRUCK.
-NO TRAILER.
-Drill is available separate - Please contact HDD Broker for details and pricing.
